Cartek Power Distribution Panel – 8 Channel CTKCK-PDP-08-

The Cartek Power Distribution Panel is a fully integrated, fully electronic solution to power distribution in race and rally cars. Designed to replace 8 fuses, relays and switches as well as a variety of control systems, these units therefore greatly simplify the wiring, reducing build time, saving weight and maximising reliability.

The Power Distribution Panel takes +12V power directly from the battery then distributes this to all the electrical systems around the car. The 8 power outputs from the Power Distribution Panel are controlled from the front panel push buttons or from external switches and inputs. All 8 power outputs are fully protected with 6 selectable current settings thereby completely removing the need for fuses or circuit breakers. The Function of each Channel is also selectable from a choice of 8 different options.

• 8 User Configurable Channels, selectable current settings of 5, 10 or 15 Amps. Combine two channels together for 20, 25 or 30 Amps. No laptop required
• Selectable functions such as momentary action (starter motor, washer pump etc), latching (with memory) – latching (without memory), latching with time delay (heated screen), flashing (indicators etc), toggling (headlights high beam/low beam)
• Over current and short circuit protection – no fuses or relays needed
• 1 Battery Isolator XR inputs – allowing the battery Isolator XR to shut down the Power Distribution Panel
• 8 Momentary switch Inputs – allowing any channel to be operated by an additional switch or the Cartek wireless control system
• 8 ECU inputs – allows the ECU to run on channels such as fuel pumps
• 4 Dedicated function inputs – flash input for lights, wash input for wipers, wiper park position etc

Unlike most PDM’s on the market the Cartek Power Distribution Panel does not need a laptop to program the configuration. Pre-set options for functionality and current settings can be chosen by going through a simple process via the switch panel. This saves the user time and any potential labour costs in setting it up. A choice of pre-crimped or loose crimped connector kits are available separately to make the installation of the Power Distribution Panel easier.

The Distribution Panel measures W140mm x H145mm and weighs 450g